It you keep the thred tight and push it together with tweezers as you go, you can get it so close together cant see threw itYota wrote:Yeah I had a good close look and couldn’t see the threads, also the bottom edge is a bit wavy - unlike a thread wound end if you know what I mean.
Ha ha. That would be easier if I just heat shrink them in place and glue them up. I guess it wouldn’t be so strong though.
- Rank: Premium Member
- Posts: 8479
- Joined: Thu Apr 26, 2012 5:16 pm
- Has liked: 20 times
- Likes received: 111 times
I have built / repaired many rods over the years. If I can suggest the easiest way, without great expense that I found very effective. Place your spool of thread in a glass, to stop it rolling away on you, then take the thread and close an old phone book or similar on the thread to tension it. The more or less tension you need is simply adjusted by how much of the book you close on the thread, if that makes sense ? Then you can sit there with the rod in your lap and twirl away, use an old teaspoon or similar to keep threads pushed snug. A few coats of binding filler to preserve color and snug threads down, followed by a few coats of rod varnish or a two part epoxy. With a little practise you will be amazed at the quality you can achieve. Just be careful not to mix brands of filler and varnish as some are not compatible. Example if you use speed brand filler, then use speed brand varnish, if you use Erskine filler, use Erskine epoxy etc